Caldigit HDElement Manuel d'utilisateur

Getting Started

10Connect the other end of the Mini-SAS cable to the Mini-3. SAS port on the back of the HDElement.Plug in the environmental control cable between the

11Note: If you have more than one CalDigit HDElement and wish to connect the environmental control cable, please daisy chain the CalDigit HDElement by

12For more information on how to congure your RAID, Please visit http://www.caldigit.com/RAIDShieldDemo.asp Thank you for choosing the CalDigit RAID

13● MiniSAS Cable 1M (Part # CBeMiniSAS-3 SKU# 702103)● MiniSAS Cable 1.5M (Part # CBeMiniSAS-4 SKU# 702104)● MiniSAS Cable 2M (Part # CBeMiniSAS

CalDigit HDElement Getting Started Manual v1.0 www.caldigit.com ©Copyright 2008 CalDigit, Inc. All Rights Reserved

Apple, Apple Logo, Mac, the Mac logo, Macintosh, are trademarks of Apple Computer Inc. Microsoft, Windows and Windows Logos are registered trademarks

3Installing your CalDigit HDElementInstalling the CalDigit RAID CardPlease install your CalDigit RAID Card rst. Make sure you also install the latest

4If you already installed your CalDigit RAID Card in your workstation, please proceed with the following steps to set up your CalDigit HDElement.Bef

5Key Hole - for access to the drives2. Mini SAS port - Connecting the CalDigit HDElement and 3. the CalDigit RAID CardKey Hole

6Mini-Phone jack - use for environmental control cable to 4. monitor the environmental dataID Switch - Assigning different ID's to multiple CalD

7Power Supply6. Key7.

8Conguring your CalDigit HDElementYou will need to rst determine your ID switch position 1. before you start the conguration. If this is the rst C

9Connect the Mini-SAS cable to the RAID Card and the Mini-2. SAS port on the CalDigit HDElement. Please connect you rst CalDigit HDElement to port 5-